The MBA Baby Boomer™ Offset Arm
$14.95

MBA

$14.95

QTY:

The Baby Boomer™ is a mounting arm that attaches to the top of your light stand to allow offset mounting and extension of your flash unit 8 inches out from the top of the stand mount.

With the direct, top-mounting of standard light stands, positioning is limited by the size of the flash and the attached accessories – particularly restricted to a small range of angle adjustments when large accessories are present. The Baby Boomer™ eliminates these frustrations by offering a wide range of motion for your flash, especially useful with large accessories such as the Retro Laser™ Reflector, the Beauty Dishes and the PLM™ System. Whereas standard, upright mounting allows only a few degrees of adjustment, the Baby Boomer™ provides clearance from the stand so that your flash unit and accessories can be angled and tilted over a much broader range, allowing extreme down-angle positioning.


The heavy-duty zinc alloy arm supports all Paul C. Buff™ flash units with a variety of faceplate accessories, attaching to the top coupler of our 13-foot light stands (and similar light stands from other manufacturers having a standard 5/8-inch connection). We recommend the use of our LS3900 or TS13AC heavy-duty light stands with the Baby Boomer™ as the offset positioning makes the setup top heavy. When used with larger accessories, particularly the PLM™ System and softboxes/octaboxes, sandbags or other weights may be needed.

Please note: With the location of the mounting block on AlienBees, and the flat rear surface of the new HOBD and HOBD-W, there is not any additional range of motion gained when using these two products together.